500mm x 1000mm Picket Panel Golf Simulator Wall and Ceiling Protection Single Panel

The Picket Panel is a unique, installer-friendly wall protection panel designed specifically for golf simulator bays. The profile has a clean, repeating picket-fence look that creates a premium finish when panels are stacked and installed side-by-side.

Each panel is 500mm x 1000mm x 50mm and designed to align neatly so the profile repeats continuously across the wall for a tidy, professional result.  These are sold as individual tiles.  Packs are available here.

Key benefits

• Premium repeat pattern - designed to stack and butt together for a continuous profile
• Fast coverage - 1000mm height reduces install time vs smaller tiles
• Built for simulator impact zones - protects walls/ceilings from repeated ball strikes
• Helps reduce rebound + noise - adds cushioning and softens the room
• Easy to plan + easy to expand - add packs later and keep the pattern consistent

What these panels protect

• Walls and ceiling from direct ball strikes
• Reduces ball rebound and noise in the room
• Protects against repeated impact over time

Picket Panel placement for a premium finish

The Picket Panel is made for installers who want a clean, consistent look without fiddly alignment. Because the profile repeats, you can create a continuous run across side walls (and ceiling areas where required) that looks intentional and high-end - ideal for customer-facing installs.

The 1000mm height means fewer joins and quicker coverage, while the 50mm thickness gives substantial cushioning in high-impact areas.

Layout planning

For the best finish, plan your layout before you spray any adhesive:

1. Start with a level first row. The profile is visible, so keeping the first panel straight is key.
2. Build in a consistent direction. Work left-to-right (or right-to-left) so the repeat stays uniform.
3. Avoid thin slivers. Measure wall height and aim to finish with a sensible top/bottom cut (if needed).
4. Keep surfaces consistent. If you're mixing panel types, avoid placing thinner tiles on the same wall where a visible step would show.

Installation

These panels are designed for straightforward install using a quality spray contact adhesive. Installation in 3 simple steps:

• Prep the surface: clean, dry wall - no primer needed
• Apply adhesive: spray both panel and wall, wait ~60 seconds
• Press and finish: firm press, trim edges if needed

Tip: Apply adhesive evenly across the full panel so the profile bonds properly and stays flat.

FAQs

• Q: Do these panels line up as a repeat pattern?
  A: Yes - they're designed to be stacked and installed side-by-side so the profile repeats continuously across the wall.
• Q: Are Picket Panels suitable for a full bay install?
  A: Yes - they're ideal for side walls and other impact zones. For the most premium look, keep the same panel type across the main visible surfaces.
• Q: How do I work out how many packs I need?
  A: Measure the areas you're protecting and use the Panel Calculator to get exact quantities and adhesive amounts.
• Q: Are they harder to cut than flat tiles?
  A: The profile means cuts take a bit more care. Use a sharp blade and multiple light passes for clean edges.
• Q: Do they help with acoustics too? A: Yes - the foam absorbs sound like our other panels, and the profiled surface can help with additional absorption while also giving a premium aesthetic.